Tuesday, August 6, 2013

Paper Straw Airplane

Look what we made!


Oh - not clear?  It's an airplane!  And it is a crazy good flier.  Want to see how we did it?


First we gathered the supplies.  Each plane will need a paper straw, a strip of paper approximately 1 inch by 10 inches, a strip of paper approximately 1 inch by 5 inches, and a few pieces of tape.  We used some pretty new washi tape I picked up at Target (yes, TARGET!) but any tape should do.


I don't really have any process shot because, apparently, the paper/tape/four little hand combo doesn't mix well with process shots.  Basically, you loop each paper into a circle and secure with tape.  Then tape one end of each straw to a small circle, and the other end to a large circle.  


If you carefully line up the circles so they're taped to the same side of the straw your plane will fly nice and straight.  If you're off a little the plane tends to fly in a corkscrew pattern, which is also cool.  That was just an observation, no specific studies done.

So now that you've assembled your planes - pick your favorite...


...wind up and...toss!  We found that it's best to give them more of a gentle push into the air than a throw - they seemed to glide farther.  Again, no official study done - just our observation.


We make.  We fly.  And then we rest.


I was inspired by this post which was inspired by this post.  And this kid, of course.  He's pretty inspirational, too.

2 comments:

  1. fun! I wish you hadn't mentioned Target, though. Target is my weakness!

    ReplyDelete
    Replies
    1. Right? That store is dangerous! Last week I went in with a specific list and budget of $15. Walked out and hour later and $75 poorer! Worst part - no regret! ha!

      Delete